Dwellvista Straps
Fit pass from measure to hole punch
Five steps keep lug width and wrist curve honest before the final punch.
How we work
Lug & wrist measure
We record lug width, thickness, and wrist circumference with the watch on the bench.
Hide selection
You choose face leather, lining, and stitch color from swatches under daylight lamps.
Cut & stitch
Straps are cut in pairs, edges beveled, then saddle-stitched by hand.
Edge burnish
Gum and heat smooth the edges so they resist fray at the buckle bend.
Fit pass
You wear the strap for a few days; we punch the final hole and adjust keepers if needed.
Materials
Keeper loops are skived thin so they hug the strap without chewing the grain when you slide the buckle home.
Hole spacing starts from a mid wrist mark; we leave blank leather beyond the last punch until the fit pass confirms reach.
Quick-release spring bars are fitted only when lug drillings are clean—forced bars leave scars we refuse to hide with dye.
Suede faces get a light brush before handoff so nap direction matches across the pair.
Stitch length stays consistent at the buckle tongue where stress concentrates during daily on-off cycles.